HomeProductsMachinesArticlesAboutReviewsSupport

Ariens Control Levers

Ariens Control Levers
Ariens control levers provide ergonomic operator interfaces for engaging auger and traction drive systems, featuring squeeze-grip designs that require continuous pressure for safety compliance. The snowblower control lever Ariens and Ariens drive lever assemblies include cable attachment points and pivot mechanisms, whilst the Ariens handle control lever and replacement control lever components integrate with handlebar mounting systems. Available in left-hand traction and right-hand auger configurations across all model series, these cast aluminium levers ensure reliable system engagement. We hold control levers in stock and sell worldwide.

Frequently Asked Questions

Why is my control lever stiff or hard to squeeze?
Lack of lubrication at the pivot point causes stiffness. Apply light oil or silicone spray to the lever pivot pin. Over-tightened cables also create excessive resistance. The return spring may be too strong or corroded. In cold weather, lubricants can thicken, making levers temporarily stiff until warmed up. If lubrication doesn't improve operation, check that cables aren't binding and springs haven't lost flexibility due to age.
Can I replace just one control lever?
Yes, control levers are sold individually as left-hand (traction) and right-hand (auger) assemblies. When replacing one lever, inspect the other for similar wear or damage. Ensure you order the correct side and verify model compatibility, as lever designs vary significantly between model years. Installation requires disconnecting cables, removing the pivot pin, and reversing the process with the new lever.
What causes control levers to crack or break?
Impact damage from dropping the machine or striking handles against obstacles causes immediate cracking. Metal fatigue from thousands of squeeze cycles creates stress cracks over time, particularly at the pivot point. Cold temperatures make metal more brittle. Operating with severely over-tightened cables transfers excessive stress to the lever. Once cracked, levers must be replaced immediately as they can fail completely during operation.
How do I prevent levers from freezing to the handlebar?
Moisture accumulates between the lever and handlebar, then freezes. Before storage or during wet conditions, wipe the lever and handlebar dry. Apply a light coating of silicone spray or dry lubricant to pivot points and contact surfaces. Store the machine in a dry location when possible. If levers do freeze, warm them with your hands rather than forcing movement, which can damage the pivot mechanism or cable connections.
Should control levers return to the off position by themselves?
Yes, return springs should pull levers back to the disengaged position when released. This is a critical safety feature that stops the auger or drive when you let go. If levers don't return fully, check spring condition, cable routing for binding, and pivot points for corrosion. Never operate with levers that don't return properly, as this creates dangerous situations where equipment continues running when controls are released.